Home / Resources / HP Printers Troubleshooting Guides
HP Printers Troubleshooting Guides
HP Printers
Standard Error Codes
02
Warming up (if> 3 minutes, see error 50)
11
Paper out
12
Printer open
13
Paper jammed. Sensor broken or paper out of position.
14
Toner low
18
MIO not ready/Init
20
Memory error. Document too complex for available memory or memory simm has gone bad.
21
Print overrun
22
IO configuration, Par, MIO error
23
IO not ready
24
Job memory full
25
XXX Memory full
30
PS error
41
Temporary print engine failure. Power cycle. If that does not work, the DC controller, scanner assembly, or fuser optic cable may be broken depending on the model LaserJet.
50
Fuser malfunction. Power cycle. If this does not work either the AC power module, DC controller or a combination may be bad.
51
Loss of beam detect. Power cycle. If problem continues, scanner assembly, scanner cables or DC controller maybe defective.
52
Scanner error. Power cycle. Defective scanner or scanner cables.
53
Accessory memory full
54
Duplex feed error
55
Internal communication problem
56
Output Selector II/IIID/III/4si
57
Incompatible memory card
57.X
Fans, mail motor, DC controller
58
Fan, fan cable, DC controller
59
Add memory
60-68
Simm memory/Formatter
69
Remove optional I/O PCA
70-71
Persoanlity cart/SIMM incompatible
72
Replace font cart or formatter
79
Formatter defective or non-standard add-on maybe defective (i.e. font cart, simms, MIO card etc.)
80
MIO error. MIO card or formatter is defective.
81
Replace formatter PCA
89
PostScript ROM failure
Blank
Defective display panel
FS
Disk Failure 4V only (printer detected disk failure)