| 02 |
Warming up (if> 3 minutes, see error 50) |
| 11 |
Paper out |
| 12 |
Printer open |
| 13 |
Paper jammed. Sensor broken or paper out of position. |
| 14 |
Toner low |
| 18 |
MIO not ready/Init |
| 20 |
Memory error. Document too complex for available memory or memory simm has gone bad. |
| 21 |
Print overrun |
| 22 |
IO configuration, Par, MIO error |
| 23 |
IO not ready |
| 24 |
Job memory full |
| 25 |
XXX Memory full |
| 30 |
PS error |
| 41 |
Temporary print engine failure. Power cycle. If that does not work, the DC controller, scanner assembly, or fuser optic cable may be broken depending on the model LaserJet. |
| 50 |
Fuser malfunction. Power cycle. If this does not work either the AC power module, DC controller or a combination may be bad. |
| 51 |
Loss of beam detect. Power cycle. If problem continues, scanner assembly, scanner cables or DC controller maybe defective. |
| 52 |
Scanner error. Power cycle. Defective scanner or scanner cables. |
| 53 |
Accessory memory full |
| 54 |
Duplex feed error |
| 55 |
Internal communication problem |
| 56 |
Output Selector II/IIID/III/4si |
| 57 |
Incompatible memory card |
| 57.X |
Fans, mail motor, DC controller |
| 58 |
Fan, fan cable, DC controller |
| 59 |
Add memory |
| 60-68 |
Simm memory/Formatter |
| 69 |
Remove optional I/O PCA |
| 70-71 |
Persoanlity cart/SIMM incompatible |
| 72 |
Replace font cart or formatter |
| 79 |
Formatter defective or non-standard add-on maybe defective (i.e. font cart, simms, MIO card etc.) |
| 80 |
MIO error. MIO card or formatter is defective. |
| 81 |
Replace formatter PCA |
| 89 |
PostScript ROM failure |
| Blank |
Defective display panel |
| FS |
Disk Failure 4V only (printer detected disk failure) |
| PC |
Install 4V only (paper casette tray problems) |
